View Full Version : switch timing, which holes?
March 8th, 2005, 10:00 PM
i want to check the timing on my switchback which holes on the cam do i use? the big and the small holes or the two small holes?
March 9th, 2005, 11:13 AM
Use the two small holes. Lay a straight edge across the holes. If the straight edge is tilting towards the riser put twist in the cable on the cam end. If it tilts towards the string put equal amounts of twist in both ends of the string. Remember to take all measurments at max poundage and back limbs off seven turns before presing. Hope this helps. :)
March 10th, 2005, 12:29 AM
Powered by vBulletin® Version 4.2.0 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.