PDA

View Full Version : Allegiance center shot.



LongDraw1970
March 20th, 2005, 09:47 PM
all you guys that shoot an Allegiance; what is your centershot measurement?

I will be setting one up early next week (when the new TT arrives) I would Like to get it as set up as close as I can before I fling any arrows.

Thanks in advance!

Fred DeLozier
March 21st, 2005, 01:40 PM
1 1/16 inch from riser to center of shaft. Level with upper half of berger hole.

Allegiance 28/60, Carbon Express maxima 350.

bboswell
March 21st, 2005, 02:13 PM
Surely 1 1/16 is too much???

raise your T Taker and look from the top of the bow, make sure the shaft is in line with both Limb bolts, now go to either paper tune or broadhead tuning.

jonnybow
March 21st, 2005, 03:02 PM
Actually 1 1/16" is way too little. I'm getting somewhere in the 1 3/4 range, closer to 1 11/16".

Jon

alain
March 21st, 2005, 04:09 PM
Actually 1 1/16" is way too little. I'm getting somewhere in the 1 3/4 range, closer to 1 11/16".

Jon

Just like mine 1 3/4 to 1 11/16 from the outside of the riser

Fred DeLozier
March 21st, 2005, 04:21 PM
Also checked with Richard Mccarty at Lake Country Archery in east tx. Richard is ate up with getting bowtechs shooting the best they can. He sets all of his Allegiances up at 29/32 for starts. Get rid of grip torque. This bow is a little finicky about torque. Richard said he has seldom had to move from this setting.

jonnybow
March 21st, 2005, 07:56 PM
I guess you could set it up at 1/4" if you chose. We had a discussion on here about this same question and at least 10-15 folks answered with the same distance. I'm a dealer and haven't found any problems or any that wouldn't centershot at the distance I posted. I just shot my own this weekend in a tournament for its first outing and it shot lights out.

If you set yours up at 2" and it shoots well, god bless ya.

Just trying to help.

Jon

jrb CO
March 21st, 2005, 08:29 PM
The riser is about 3/4" thick.

15/16" - 1 1/16" from the inside of the riser equals
1 11/16" - 1 13/16 from the outside of the riser