PDA

View Full Version : 2011 Outlaw Grip side plates?



HarveyScorp
February 7th, 2013, 08:19 PM
Hey everyone,

I have a 2011 Diamond Outlaw. I love this bow, but hate the grip. the grip caused me to torque too much. So I took it off, but hated looking at the bare grip so I screwed the little black side plates back on without the grip. So my question is if there is anywhere other than Torqueless to get side plates? Does anyone on know someone who makes custom plates? I was talking to a guy on ebay who made custom plates, but he disappeared.

Thanks in advance.

hnkusp45
February 14th, 2013, 10:34 PM
Hi, you can use the Bowtech Invasion side plates or the Bowtech/Diamond side plates from http://www.torqueless.com/. There's a lot of color choices with the torque-less but they cost just a tad bit more than the Invasion plates. However, to my knowledge they only come in grey/red. I picked up a set for my Black-ops Assassin from my local dealer for $35 and I'm satisfied with them. I have read that the torqeless are nice though. Your call, hope this helps you out.

HarveyScorp
February 15th, 2013, 12:31 AM
Thanks, always appreciate feedback/comments.

RNMike
August 29th, 2013, 05:07 PM
Hey friend, I know this is an old post, but take a look at Rattler Grips. I have some made by Rob at Rattler Grips out of water buffalo and they are beautiful!

Cru3rd
September 5th, 2013, 05:49 PM
Here's a pair from rob at rattler on my outlaw. They turned out good you just have to wait a little while on them.

http://img.tapatalk.com/d/13/09/06/me3adu9y.jpg

HarveyScorp
September 5th, 2013, 06:03 PM
Thanks, Those look nice.

RNMike
September 5th, 2013, 10:13 PM
http://img.tapatalk.com/d/13/09/06/uhunuqy9.jpg
Dig the green! Here are mine from Rattler out of water buffalo horn. Rob does amazing work!