adjusting the sight on a LH Diamond Infinite Edge [Archive] - ArcheryTalk Forum: Archery Target, Bowhunting, Classifieds, Chat

View Full Version : adjusting the sight on a LH Diamond Infinite Edge

August 31st, 2013, 08:45 PM
I just picked up a LH Diamond Infinite Edge for my son. It comes with a 3 pin Apex sight. As we were out sighting it in I discovered that it's nearly impossible to tighten down the elevation adjustment because the screw head is on the bottom next to the frame. There's no way to get a wrench on it. Obviously if this sight was put on a RH bow then it wouldn't be a problem. Any suggestions? Do I need to LH sight? Anyone else shooting a LH infinite edge and dealt with this? I'm fairly new to archery so any help would be appreciated.

September 1st, 2013, 12:38 AM
I have one for my wife. I just used a ball drive Allen key. I didn't find it all that tricky at all.

September 1st, 2013, 03:39 AM
Had the same issue with my wife's LH IE. Just went a head and replaced it with an inexpensive TruGlo sight that was easy to adjust without anything in the way.

September 1st, 2013, 12:40 PM
We had to turn the sight down and there's no way to even get the ball end of an Allen wrench on it. Thanks for the replies though. Love the bow but it seems a LH bow should come with extras that work.