View Full Version : Diamond Stud Limb Pocket Bolts
March 26th, 2014, 09:35 AM
Hey everyone, I found a new Diamond Stud (2010) still in the original box, It was already set to 60lb but when looking at the manual it says after making a poundage adjustment to make sure you tighten the (2) limb bolts which are shown on the inside of the riser near the Limb Pocket. Anyone know if this bow is equipped with these because I do not see them. Any Help would be appreciated!
March 27th, 2014, 04:17 PM
if you dont see them, then they are probably not there. i havent messed with that particular model, but they arent hard to find. Diamond likes to use the same manual for multiple bows, so sometimes, things dont cross over to all models.
March 27th, 2014, 04:19 PM
i dont remember the stud with them either, the manual is pretty generic in it can cover all the years models, just the one top bolt on limb and your good to go
March 27th, 2014, 07:49 PM
Sounds good i was hoping that was the case i have worked on a few bows with those bolts on the inside of the limb just wanted to be sure. Thanks!!!
Powered by vBulletin® Version 4.2.0 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.