Archery Talk Forum banner

question about scoring...

465 views 3 replies 3 participants last post by  The Hood 
#1 ·
does someone on here no which measurements are used ?

I started to measure a rack of my dad's, and only got 126 4/8" and i know it's way bigger than that.

I did the following measurements:

Inside Spread
RT. beam length
LT. beam length
G1 length both sides
G2 length both sides
G3 length both sides
G4 length both sides

am i missing anything?

here is a pic of the rack... thanks in advance.

Lee
 

Attachments

See less See more
1
#2 ·
You're missing the mass measurements. You record the smallest diameter between the burr and G1, smallest diameter between G1 and 2, smallest between 2 and 3, and between 3 and 4. On a 4 point frame however the final mass measurement is taken at a point halfway between the 3rd point and the end of the main beam. On this deer there is no G4 measurement. www.boone-crockett.org can provide you lots of online scoring help also for where measurements need to be taken and other general info.
 
#3 ·
ahhhhaaaaaaa!!!

thanks buddy, i knew i was missing something, appreciate it.

so if i stick my foot between the tape and the smallest area between the tines, i should end up with a 200 incher eh?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top