Archery Talk Forum banner

Alphmax let-off qustion?

684 views 3 replies 3 participants last post by  onetohunt 
#1 ·
Can let-off be adjusted on a am32....the owners manual is not clear on it. I would like the 75 percent.

Its a xr3-br cam 28" draw the peg is in the "a" hole.

thanks for any tips.
 
#2 ·
I think I figured it out, it was out of time a little, got it back in time and ata is dead on and brace height is dead on. Plus is dead on 70lbs max weight.

Very impressed with the bow so far.

I have a good size nock high tear I will work on later today...any suggestions to cure that? I think I have the rest at 90 degrees to the string.....

please advise.
 
#3 · (Edited)
Those cams are 75 % letoff only. I've had the best results with my rest set so that the shaft is directly centered with the berger button hole - nock point set to leave the arrow shaft at 90 degrees with the string.
 
#4 ·
Knock high tear. What kind of rest are you using? If a drop away, make sure your arrow is a little above the berger button hole. Also check your spring tention on the rest as well.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top