Search Results - ArcheryTalk Forum: Archery Target, Bowhunting, Classifieds, Chat

       

Search:

Type: Posts; User: archer58 in pa

Page 1 of 34 1 2 3 4

Search: Search took 0.82 seconds.

  1. Replies
    17
    Views
    355

    I've tuned a crap ton of Elite's and every one...

    I've tuned a crap ton of Elite's and every one has set up with the arrow 90 degrees off the string through the middle or slightly high on the burger hole.
    Nock low is usually a guidance issue. I...
  2. Replies
    5
    Views
    212

    Here ya' go Ken. 4573945 4573961 Ken's 34...

    Here ya' go Ken.
    4573945
    4573961

    Ken's 34 tuned up very well. After a little trouble figuring out the timing on the TT Shakey Hunter
    and getting the right person to shoot it,(since I am a...
  3. Replies
    5
    Views
    212

    That's a fuzzy pic I took. I'll post a better...

    That's a fuzzy pic I took.
    I'll post a better one before I box it up tonight.
  4. Replies
    6
    Views
    196

    I had strings made to 2015 specs also. 1/4" long...

    I had strings made to 2015 specs also. 1/4" long ATA initially. Yours shouldn't have been 1/2".
    A few twists and it's good to go.
    No need to go to 7/8" if you are getting good results at 13/16". I...
  5. Replies
    6
    Views
    196

    If your ATA is off by 1/2" you need to get it...

    If your ATA is off by 1/2" you need to get it back to spec. 1/2" is WAYYYYY too much to be off.
    He must not be familiar with Elites. Are you sure the string lengths are correct?
    I wouldn't take it...
  6. Replies
    67
    Views
    1,927

    I'm a lefty all the way. I don't seem to find...

    I'm a lefty all the way. I don't seem to find deals anywhere cause there are no lefty bows to get a deal on.
    The shop that carries my preferred brand had one lefty this year.
  7. Replies
    244
    Views
    4,436

    What is this discussion about again? Sent...

    What is this discussion about again?

    Sent from my SCH-I545 using Tapatalk
  8. Replies
    26
    Views
    617

    I have the arrow dead level right now. We'll see...

    I have the arrow dead level right now. We'll see what we get.
    I have a combo tear now.
    I'm more concerned with the nock right.
    Hoping the activation cord cable position caused it.
  9. Replies
    26
    Views
    617

    Interesting you posted this thread. I'm tuning...

    Interesting you posted this thread.
    I'm tuning an Impulse 34 with a TT Shakey hunter for a member here.
    I'm getting the exact same tear.
    I reset the activation cord at almost the top of the grip...
  10. Replies
    22
    Views
    727

    The tears are not good for any of your arrows. I...

    The tears are not good for any of your arrows.
    I think you have a tuning/grip issue. You should also spin check your broadheads.
    Get your bow shooting bullets THEN put the lighted nocks and bh's on...
  11. Replies
    29
    Views
    991

    [For Trade] message sent

    message sent
  12. Replies
    90
    Views
    4,675

    Absolutely. Binarys are easier to tune by far....

    Absolutely.
    Binarys are easier to tune by far. Sometimes simple is better. In this case I'd say it sure is.
  13. Replies
    90
    Views
    4,675

    I agree with ya. I don't think a split limb or...

    I agree with ya.
    I don't think a split limb or yoke would benefit much.
    If you yoke the cable ,wouldn't you have to change the cam system? It then become a hybrid??, not a binary.
  14. Replies
    29
    Views
    814

    Yes they are. I couldn't agree more. I should...

    Yes they are. I couldn't agree more.
    I should say again that I may not have the grip mechanics to attain a clean BS shot.
    The arrow is aligned down the middle and it shows in my groups.
    Shane gave...
  15. Replies
    29
    Views
    814

    As I moved back the arrows started to drift...

    As I moved back the arrows started to drift right....probably 2 inches,
    The left angle also got worse.
  16. Replies
    1
    Views
    143

    I have always taken 1/4 turn out. But that's just...

    I have always taken 1/4 turn out. But that's just what I have done.
    Bottomed out should be OK.
  17. Replies
    29
    Views
    814

    I'm convinced that the 7/8" CS is more correct...

    I'm convinced that the 7/8" CS is more correct for these bows. You just can't get arrow alignment at 13/16". At least not a E32.
    It seems from your statement on rod position and Shane's rod position...
  18. Replies
    29
    Views
    814

    Alright. I'll give it a try.

    Alright. I'll give it a try.
  19. Replies
    29
    Views
    814

    That's the was I had it set before. 13/16" CS and...

    That's the was I had it set before. 13/16" CS and rod at 5:30.
    I had no problem tuning but the arrow pointed in towards the riser. BS was terrible set this way.
    The only way I could see to align...
  20. Replies
    29
    Views
    814

    I watched the video, and that's very similar to...

    I watched the video, and that's very similar to how I grip the bow.
    Are you saying less thumb pad on the grip?
  21. Replies
    29
    Views
    814

    I'm running a RAM slide also and that could be...

    I'm running a RAM slide also and that could be some of the difficulty I had today with the BS.
    I had some wind to deal with this afternoon but was able to shoot later.
    At the 7/8" CS setting BH...
  22. Replies
    29
    Views
    814

    NO stir IMO. I'm ALWAYS looking for advice....

    NO stir IMO.
    I'm ALWAYS looking for advice. Never too old to learn.
    I'll let you know how it works out. Thanks for the post on your 31.
  23. Replies
    29
    Views
    814

    Your bow/arrow line up down the middle and that's...

    Your bow/arrow line up down the middle and that's exactly what I'm looking for.
    At 13/16" the arrow did not line up. It pointed into the shelf like many here have shown on their Energy bows.
    I had...
  24. Replies
    29
    Views
    814

    A Ram slide Skeet. But I can't see what would...

    A Ram slide Skeet.
    But I can't see what would make the difference as long as the tension is similar.
    You'd just move the rod a little more than the other.
  25. Replies
    29
    Views
    814

    That's my plan for tomorrow if the wind stays...

    That's my plan for tomorrow if the wind stays calm enough.
    I'll post up results for sure.
  26. Replies
    29
    Views
    814

    E32 tuning tale

    If you have seen Shane's(OnTarget7) thread about his 2 I31's you probably saw a reference to the CS
    and cable rod setting he tuned his bows to.
    I read the 7/8" CS statement and thought this would...
  27. Replies
    12
    Views
    408

    If I am looking at the pics correctly, it looks...

    If I am looking at the pics correctly, it looks like you're pretty good.
    MAYBE 1/2 a twist will get the cams perfect. You could try a 1/2 but I think
    you're close enough to move a stop. It...
  28. That works. Thanks bud.

    That works. Thanks bud.
  29. Still stops when you start talking about the left...

    Still stops when you start talking about the left edge of the grip.
    I'll try my wife's laptop.
  30. The video stops for me too. Shane, Can you post...

    The video stops for me too.
    Shane, Can you post it here? Maybe I can get it to full run.
Results 1 to 30 of 1000
Page 1 of 34 1 2 3 4