Search:

Type: Posts; User: Moon

Page 1 of 34 1 2 3 4

Search: Search took 1.05 seconds.

  1. I hope they change that name for 2016. I guess...

    I hope they change that name for 2016. I guess they wanted to get the point across, but damn!!!!:-) I think they will take the 390 to 400 for those that are mesmerized with the number 400:-), make...
  2. Replies
    15
    Views
    206

    You'll have to decide:-) Do some shopping and...

    You'll have to decide:-) Do some shopping and comparing and you will know.
  3. Replies
    5,404
    Views
    285,283

    I was surprised to see how little difference...

    I was surprised to see how little difference there is in accuracy at 50 yards as compared to a scope in the 3 to 4 power range. There is a difference but, IMO, not a practical difference.
  4. Replies
    5,404
    Views
    285,283

    I have a recurve that is using an old Middleton...

    I have a recurve that is using an old Middleton riser, shortened Excal riser and Matrix limbs. It's the brother to the one I sold Hunlee. The power stroke on it is right at 11 3/4". It shoots a 20"...
  5. Replies
    5,404
    Views
    285,283

    Z, I'll likely end up with the same conclusion:-)...

    Z, I'll likely end up with the same conclusion:-) I know Acetone works for me. I'll test the adhesion of these vanes tomorrow. Just fletched them this morning. I'll give the glue a day to "do its...
  6. Replies
    5,404
    Views
    285,283

    I'm going to fletch an old arrow this morning...

    I'm going to fletch an old arrow this morning using only one of those wipes. I don't see how it can be as good as acetone.
  7. The 350, according to dealers, had no limb...

    The 350, according to dealers, had no limb problems as the old 380 did. The thing I'd be looking for is if the 350 is the original arrow hold down arm version or the newer non metal version.
  8. Replies
    136
    Views
    3,896

    Some folks "on here" can't even find a hunt club...

    Some folks "on here" can't even find a hunt club that will keep them. Swampy worked on the edge but I saw no bitterness like being spewed by the same old same old and still getting by with it. All...
  9. Thread: Micro Lust

    by Moon
    Replies
    99
    Views
    2,766

    Those arrows on the familiar pretty table must...

    Those arrows on the familiar pretty table must not get shot much as all the decals look like new:-) Fist thing I do is remove those decals before they get smeared up from shooting.

    Where did SD go...
  10. Replies
    61
    Views
    1,380

    Speaking of Middleton........... my first recurve...

    Speaking of Middleton........... my first recurve crossbows were Excalibur ExoCet 200's. Loved those recurve hunting crossbows but they were............wide:-) I then got a Vortex and, a bit later,...
  11. Replies
    5,404
    Views
    285,283

    Has anyone tried this stuff?

    Has anyone tried this stuff?
  12. Replies
    7,079
    Views
    408,099

    What other crossbow, other than the LS 390, can...

    What other crossbow, other than the LS 390, can be cocked with a conventional cocking rope with only 77 lbs of force and shoots a 400 grain arrow right at 390 fps?
  13. Thread: 2015 Bow quality

    by Moon
    Replies
    27
    Views
    892

    As long as they look like these, I'm good.

    As long as they look like these, I'm good.
  14. Replies
    136
    Views
    3,896

    "Chit"? Look in the mirror:-) Looks like you...

    "Chit"? Look in the mirror:-) Looks like you two should practice what you preach, especially you, mr. got your telephone number and address. BTW, you have no idea what "my place" is.....only a...
  15. Replies
    7,079
    Views
    408,099

    Ramrod, it's just one of the many reasons I like...

    Ramrod, it's just one of the many reasons I like the LS 390.................but you already knew that:-)
  16. Replies
    7
    Views
    187

    Gene, you guys are hard on the turkeys up...

    Gene, you guys are hard on the turkeys up there!!!!:-)
  17. Replies
    5,404
    Views
    285,283

    I'm still using the tiny blue tubes of LocTite...

    I'm still using the tiny blue tubes of LocTite gel. They are packaged 3 per pack and I keep the in the refrigerator in the shop. The life is so short on this type of glue I figure the smaller the...
  18. Replies
    7,079
    Views
    408,099

    I think it should be a little lower or closer to...

    I think it should be a little lower or closer to the rail but, other than that, it's rock solid.
  19. Replies
    136
    Views
    3,896

    There are 2 kinds of posters on most forums,...

    There are 2 kinds of posters on most forums, those that want to help people enjoy their chosen sport as much as they do and a few others that thrive on pizzing folks off that they don't agree with or...
  20. Replies
    136
    Views
    3,896

    The judge has spoken:-)

    The judge has spoken:-)
  21. Replies
    136
    Views
    3,896

    'What does get old is a few guys taking every...

    'What does get old is a few guys taking every opportunity to exercise their personal vendetta in every thread that the other is writing in. They can't both make a post without including an unrelated...
  22. Replies
    5,404
    Views
    285,283

    I've settled on RamCats. Less target damage, less...

    I've settled on RamCats. Less target damage, less pulled inserts and they shoot with virtually the same POI as field points. the new blades without the needle points hopefully will be ready next...
  23. Replies
    70
    Views
    1,757

    "hear is the chitz......i often speak...

    "hear is the chitz......i often speak off....lifting your hands over you head.... really?" Fact is most crossbow hunters are over 50, lots of them with shoulder problems and the reason they are...
  24. Replies
    23
    Views
    380

    That'll work for sure:-) I normally do what 109...

    That'll work for sure:-) I normally do what 109 does and the screw can be saved. Dave, keep the video's coming:thumb:
  25. Riflemanz, you sure you aren't hunting my field?...

    Riflemanz, you sure you aren't hunting my field? :wink: This field is one of my favorite hunting spots. Been known to produce a nice buck from time to time.
  26. Replies
    70
    Views
    1,757

    Nice, 109:-) Obi, you can build what you want...

    Nice, 109:-) Obi, you can build what you want now. It would be cool to see Excal open a custom shop to build you what you want, triggers, stocks, various camo's, etc.........for about...
  27. Replies
    5,404
    Views
    285,283

    I guess I should not be joking about stuff like...

    I guess I should not be joking about stuff like that. It's the most weird sound I've ever heard in my life.
  28. Replies
    5,404
    Views
    285,283

    Have you heard about the ringing trumpet sounds...

    Have you heard about the ringing trumpet sounds coming out of the sky and being heard around the world? :-) I think I've figured it out:-) I think it's the millions of Micro's being shot...
  29. Replies
    70
    Views
    1,757

    No cams or wheels, no bushings or bearings to...

    No cams or wheels, no bushings or bearings to wear out, no timing issues, no severe string angles that separate center servings, no lifting your hands over your head to cock one, no machinery needed...
  30. Replies
    70
    Views
    1,757

    No1, I read the above with a smile on my face....

    No1, I read the above with a smile on my face. I'm wondering why you insist on hanging around on a recurve thread ??? Other than trying to convince folks that recurves aren't all that, there can be...
Results 1 to 30 of 1000
Page 1 of 34 1 2 3 4