Search Results - ArcheryTalk Forum: Archery Target, Bowhunting, Classifieds, Chat

       

Search:

Type: Posts; User: ironman_gq

Page 1 of 17 1 2 3 4

Search: Search took 0.33 seconds.

  1. I like the bemans as well, only a few gripes and...

    I like the bemans as well, only a few gripes and they are minor. One, they don't pull out of layered targets as nice as others which I think has to do with the gloss finish on them. Two, the factory...
  2. Replies
    18
    Views
    494

    Over 29.5 DL the rpm360 tends to have a pretty...

    Over 29.5 DL the rpm360 tends to have a pretty good hump at the end, you can play with the mods and draw stops a little to see if that helps or add or remove a twist from each cable to change the cam...
  3. Replies
    15
    Views
    469

    E clip, doesn't hold the cable on the post, it...

    E clip, doesn't hold the cable on the post, it holds the axle in. Without it the axle can walk out.
  4. Replies
    41
    Views
    1,318

    Looking pretty mangy with some thin hair standing...

    Looking pretty mangy with some thin hair standing on the back, I'd say it's a sick yote.
  5. Sounds like something I should look into, I've...

    Sounds like something I should look into, I've been using just glyphosate and tilling under anything that doesn't die. I let it sit a few weeks after the initial till and till it all under again and...
  6. Replies
    26
    Views
    495

    1/2 inch thick, salt, pepper, rocket hot grill...

    1/2 inch thick, salt, pepper, rocket hot grill and 2 minutes per side. Can't beat fast and simple, meat comes off tender and never dry. I will say that I find it helps if I let the meat come up to...
  7. Replies
    44
    Views
    1,383

    I think they are definitely worth it, we have...

    I think they are definitely worth it, we have roughly 10 acres of plots scattered through 300+ acres of property and it is a lot of fun going out and watching the does come feed all day. If you bring...
  8. Chickens eat them too. To keep them off yourself,...

    Chickens eat them too. To keep them off yourself, 40% DEET is the minimum that is effective for me Permethrin is amazing (Sawyers or get the concentrate at the local feed and seed and mix your own)...
  9. Replies
    54
    Views
    1,273

    I'm 5'-9" and have a 72" wingspan and a 28" DL

    I'm 5'-9" and have a 72" wingspan and a 28" DL
  10. Replies
    29
    Views
    947

    Never shot a HeliM but I do know that the Spyder...

    Never shot a HeliM but I do know that the Spyder 30 is a great shooter, quiet and relatively quick and very consistent when tuned properly.
  11. Here too, but not because of chemical pollution....

    Here too, but not because of chemical pollution. Here we have mercury in some of our lakes, generally the smaller ones with low water turnover rates.
  12. Replies
    16
    Views
    829

    Check the cable serving diameters of the new...

    Check the cable serving diameters of the new strings compared to the factory, mine ended up being slightly thicker and I lost a bunch of let off. Went from a true 80% down to about 70% and felt kinda...
  13. I'd say it was some old farmers idea of a joke,...

    I'd say it was some old farmers idea of a joke, wouldn't be completely impossible for a big farm boy and a few buddies to hoist 400lbs up to the crotch of an oak tree with a little good rigging and...
  14. Replies
    13
    Views
    317

    All the cameras I've seen are compatible with...

    All the cameras I've seen are compatible with FAT32 and NTFS. If your running an alternative OS on your computer just make sure you format to one of those filesystems (you get the option when you...
  15. Replies
    11
    Views
    237

    The quick fix is to just have it drained out,...

    The quick fix is to just have it drained out, they just suck the jelly out of them with a big bore needle. Quick recovery but a good chance it will come back. I'd have it drained to get you through...
  16. Replies
    29
    Views
    780

    I've seen them end up smashing into the back of...

    I've seen them end up smashing into the back of the rest on short brace height bows and damaging the rest. Tying a D-loop takes a little patience and practice the first couple times but they are...
  17. Replies
    19
    Views
    753

    I'm going with BCY like everyone else is saying....

    I'm going with BCY like everyone else is saying. If your looking for a good material for tying peeps, I like to use spectra fishing line 30lb test or heavier. It's thin, cheap and easy to work with....
  18. Replies
    10
    Views
    283

    No need to go to the shop, read the manual and...

    No need to go to the shop, read the manual and adjust it yourself. Just make sure you don't back the bolts out too far and you back them out equally. Nothing wrong with having to start out at a low...
  19. Replies
    7
    Views
    537

    arrow won't line up with the pins at rest for...

    arrow won't line up with the pins at rest for several reasons, the biggest one is riser flex followed by cam lean.
  20. Replies
    10
    Views
    657

    For me, once I get the 20yd pin set and the whole...

    For me, once I get the 20yd pin set and the whole sight adjusted, it's just a matter of setting the other pins out to 60yds. Rarely do I have to adjust pin spacing, if I need to adjust it's a whole...
  21. Replies
    28
    Views
    968

    probably a photoresistor of some variety. They...

    probably a photoresistor of some variety. They read the shadow of the projectile as a spike in resistance, one on each end of the chrono and a timer that determines how long it takes from one spike...
  22. Replies
    25
    Views
    855

    Use 6013, it's a low penetration rod that also...

    Use 6013, it's a low penetration rod that also freezes quickly. 3/32 or 1/8" and if you can make it a lap joint you'll have an easier time. .10 is nearly an 3/32 so not super thin but not ideal for...
  23. Replies
    48
    Views
    789

    2.5" Wednesday night, maybe another inch on...

    2.5" Wednesday night, maybe another inch on Monday. Been pretty dry for the past 2 weeks though
  24. Replies
    36
    Views
    1,482

    But they're so fun to troll

    But they're so fun to troll
  25. Replies
    135
    Views
    13,116

    blue locktite and the little lock washer they...

    blue locktite and the little lock washer they come with is all it should take, just check them once in a while and make sure they're snug.
  26. Replies
    25
    Views
    879

    We managed to find a low hour John Deere 5075e...

    We managed to find a low hour John Deere 5075e for around $28k delivered including training on the unit and implements. Shop around and don't be afraid to buy a bigger machine than you "need". When...
  27. Used to have wildfires throughout the country...

    Used to have wildfires throughout the country that would periodically thin the forests and promote new growth. For most of the country the fires don't happen any more or are very localized, a forest...
  28. Replies
    16
    Views
    488

    Simple enough to make yourself and lots of...

    Simple enough to make yourself and lots of tutorials on youtube. I've made a couple nice looking ones, takes maybe an hour to figure out and weave one up with $5 worth of paracord.
  29. Mission Craze is a no press adjustment, just move...

    Mission Craze is a no press adjustment, just move the draw mod. Infinite edge is similarly easy to change the DL.
  30. Replies
    17
    Views
    643

    I've got a ding like that on my lower cam, not...

    I've got a ding like that on my lower cam, not sure how it got there but all I did was make sure there wasn't a burr in the string track and kept an eye on it for while. 2 years and no sign of...
Results 1 to 30 of 482
Page 1 of 17 1 2 3 4