Type: Posts; User: ZuluWhiskeyFox
I'm wondering how the "New Dragon XL"compares to the "Diamond Back" in stiffness? You say the dragon XL is twice as stiff. Twice as stiff as what?
The little rubber bit at the end of the rods won't stay straight. I have tried several different types of glue. So far nothing last for long.
The "while back" was in May.
I'm about install a new string set I bought from Vaportrails. At the same time I also bought some Batwing string dampeners. A while back I bought some TPU Seed Nocks for this next string. So here is...
I tried using the online thing. It was giving me some grief. So I picked up the phone and did it the old fashion way. I actually talked to a human. Go figure. A replacement warranty part is in the...
Bought my first bow about 5 months ago. A Bear Anarchy HC 48lbs. My set up is very much that of a target bow. I am recently retired and was getting bored. I saw an article in the news paper about a...
Please enter me in the draw.
Ok. I've taken the gizmo off, retied my D-loop. I saw the error of my ways with d-loop. I had the top and bottom knots wrapped around the string in the same direction. However that error was made...
I was some difficulty with my peep staying put. It's served in. Invariably it would turn just far enough to make difficult to see through. I tried rotating the string many times. No matter what I did...
I think you're on to something on both. I could use a smaller dia scope. I try to place level in the bottom of peep the same every time. I'll spend some time with that creep tuning.
This was shot from 50 meters. Something's not right.
Ok. I struggled with that shorter draw length. I find that in order to get the string back to my face I need to bend my bow arm more. I also come to another conclusion. Without holding a bow I...
Oh my. That's going to take some practice. I'm thinking I best this under control before I do much more messin with my bow.
Almost looks like my D loop could be shorter. But it's already pretty short.
Draw length reduced 1". Now 27". Feels funny. Will take a bit of getting used to.
This is first time I've seen a pic of myself at full draw. I'm thinking I might be a little long on...
From 14 yds.
Ok so I've set both limb bolts exactly 2 turns out, top cam is 1/8" ahead, nock raised 1/8".
Result at 14 yds is point of impact is the same, bare shaft is nock low about an inch. Is the nock low...
I agree. The deflection thing is unlikely. The heal pressure in my grip is more likely.
Talk to me about this limb deflection. Forgive my ignorance but I have no idea what you're referring to.
Limb Driver for me.
Spring tension is quite high. Rest is up at its upper limit of travel. So I can't raise nock height any more.
I have the cord tied the upper axle.
Keep the ideas coming. So far I have tried all of the above. The LD I'm using is the Micro Elite. In the beginning I had some left right issues as well. My form was definitely the issue there. With...
I'm thinking what I really need is a draw board and check nock travel. So far my groups are the tightest they have ever been. I have also noticed a sizeable increase in arrow speed. My tuning efforts...
I have an Anarch HC 2014. I recently had a go tuning this thing. It's my first compound. So all is very new to me. I made a Bar Clamp Press that works very well for string changes and such. If ever I...
Count me in.
Doesn't surprise me at all. After all they were originally breed to be hunting dogs. Their sense of smell will rival any Hound out there. And being short and slow they're more thorough.
Just a thought. Try numbering your arrows. In an effort to see if that flyer is always the same arrow.