a href="http://www.lancasterarchery.com/archery-classic-register/#header">
Results 1 to 4 of 4

Thread: HELP with Hoyt tune charts

  1. #1
    Join Date
    Nov 2010
    Location
    Florida USA
    Posts
    1,067

    HELP with Hoyt tune charts

    I have 3 hoyt elite bows, a CE XT2000, CE XT3000, and a VE+ they all have the same cam 1/2. When the strings/cables are set as per the Hoyt tune charts the DL comes longer than specified in all 3 bows, also the cam angles (rotation) between bows vary wildly, like if one is at 11:00 the other is at 2:00. The DL in the CE XT3000 come 5/16" long while in the VE+ is over 1" long. I re-check my cam position and is as specified in the tune chart. I use the ATA (Archery Trade Assoc.) methods to make my measurements.

    Should I ignore the string/cables length and go for ATA, BH, and DL only?

    Why the cam angle (rotation) vary so much?

    Thanks
    Archery loco!

  2. #2
    Join Date
    Nov 2010
    Location
    Florida USA
    Posts
    1,067
    ttt
    Archery loco!

  3. #3
    Join Date
    Dec 2003
    Location
    Wisconsin
    Posts
    3,706
    Not sure i have a few hoyts and using the 100 tension on a 1/4 in post to set harness lengths i've always been fairly close. Within 1/8 ata, draw length usually long by 1/4-1/2" and BH within 1/8 with limbs tight.
    Are you 100% positive your reading the chart right for you application and lengths/??

  4. #4
    Join Date
    Nov 2010
    Location
    Florida USA
    Posts
    1,067
    Yes, and for the CEs I get better results, like you said, 1/4 to 1/2" long. Which in my opinion is far out.

    Archery loco!


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •