Archery Talk Forum banner

Cardboard sizes for field faces?

885 views 5 replies 4 participants last post by  fmoss3 
#1 ·
I'm waiting for a target face delivery and need to cut some cardboard. Are the sizes I have below correct?

Bunny = 34" X 34"
35cm = 14 3/4" X 14 3/4"
50cm = 20 3/4" X 20 3/4"
65cm = 26 1/4" X 26 1/4"

TIA
 
#2 ·
Here are the sizes I cut for our club:

Bunny 36" x 36"

35cm 32" x 32" ( four target faces - two would be 16X32)

50cm 23" x 43" (two faces)

65cm 29"x 29"

I leave a margin to make gluing easier, and cut it off afterwards if needed. I rounded-off the cut sizes, too.

Switched to paint this year instead of wallpaper adhesive, and so far the critters have left the targets alone.
 
#5 ·
If you have access to it the corrugated plastic signs (like campaign signs) work very well for target backers. Cut them about an inch longer on the ends and just use box tape to hold them down. They don't curl up like cardboard does when it gets wet. We get leftover sheets from a sign company in town. If needed you can tape pieces together to get the size you need prior to adding the target faces.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top