What's everyone’s opinion when the cam, cam bearing, limbs, and spacers don't completely fill the distance between the e-clips on the axle? Say for example the cam can be moved back and forth .008 on the axle. Should thin nylon washers be used to eliminate any movement?
I always use thin plastic washers to fill up the gap on my bow. Just make sure the cam is free to rotate. Get it too tight and it is worse that a little loose. IMO
Pete
Put the washer under the e clip. it should move the limb over. If it binds then try it inside on the axle. If there is already a spacer there under the clip should fix the problem.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Ask a question
Ask a question
Archery Talk Forum
38.3M posts
213.7K members
Since 2001
A forum community dedicated to bow and crossbow owners and archery enthusiasts. Come join the discussion about optics, hunting, performance, troubleshooting, styles, reviews, accessories, classifieds, and more!