November 15th, 2008, 07:54 PM
Should your ata measurements be exact on both sides of the limb.
I have an martin s4 with furious cams and i use the cable guard.
Right now it is a little long specs for the 07 s4 is 43.25
any help would be great.
Carter Target 4 Release
Crooked Creek Archery Shop
November 16th, 2008, 09:52 AM
There shouldn't be much difference, as that implies cam lean. But that's a good question I had never actually considered.
Checking my (9) bows, I find that my Hoyts are all off by <1/16th, to dead on. The short ATA's seem the most likely to be a bit off, and floating yokes the worst.
November 16th, 2008, 10:07 AM
times 2. BUT cam lean is not the evil animal that everyone thinks. Several winning bows have had slightly out to outrageous cam lean.
Originally Posted by TMan51
Pearson MarXman, Limb Driver Pro, Muddy Virtue HT3s, Bohning vanes, Sure Loc Challenger,
Super Ball Peep, Stanislawski MagMicro Trio, Deuce, Blackjack and TRU Ball ST360, 30" Stinger
with Stinger back bars.
November 17th, 2008, 12:42 PM
I usually try to remove as much cam lean as possible with adjustments to the yoke, but on a hybrid cam, you get what you get with the lower cam.
Originally Posted by SonnyThomas
I was wondering what you would class "outrageous cam lean" as?
By bmw4422 in forum General Archery Discussion
Last Post: February 10th, 2010, 08:25 AM
By Bowtaz in forum General Archery Discussion
Last Post: July 27th, 2009, 09:45 PM
By FatboyStew in forum Bow Tuning
Last Post: March 12th, 2007, 11:11 PM
By ghostrider46 in forum General Archery Discussion
Last Post: May 5th, 2004, 05:45 PM
By Shooter Mike in forum General Archery Discussion
Last Post: June 10th, 2003, 11:03 PM