Does anyone know of Limbs that are available for the Martin Jaguar takedown recurve? I've been told that since the Martin factory burned down, limbs from Martin are no longer available. I thought I read somewhere on this site that a Sage takedown limb might work but I have not found anything related.
Limbs for Martin Jaguar recurve
jg3under
1 - 5 of 5 Posts
Does anyone know of Limbs that are available for the Martin Jaguar takedown recurve? I've been told that since the Martin factory burned down, limbs from Martin are no longer available. I thought I read somewhere on this site that a Sage takedown limb might work but I have not found anything related.
Joined
·
2,009 Posts
I had a Jaguar for awhile. One morning I was curious about crossfitting limbs between it and the Sages. They won't directly swap but it did appear to me that I could trim the Jaquar limbs and use them on the Sage riser. That means that the Sage limbs should fit on the Jaguar riser.
If you would like, measure the diameter of the bolt hole and the pin hole on the Jaguar limbs along with the spacing between them center to center. Then measure from the butt end of the limb to the center of the bolt hole. Get those numbers to me and I will be happy to measure the Sage limbs to see how they match up.
If you would like, measure the diameter of the bolt hole and the pin hole on the Jaguar limbs along with the spacing between them center to center. Then measure from the butt end of the limb to the center of the bolt hole. Get those numbers to me and I will be happy to measure the Sage limbs to see how they match up.
Joined
·
2,009 Posts
Come to think of it, I'm not sure that there even is a pin hole. If so, just the diameter of the bolt hole and the distance to the center from the butt end will suffice.
1 - 5 of 5 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
