Archery Talk Forum banner

Inserts

21 - 28 of 28 Posts
It's interesting to see people always commenting about how halfouts are some big problem, yet I've been shooting them for years with no issues. I think material is a big factor a lot of people are ignoring. I will only use steel or titanium, no aluminum. I've shot into trees, fence posts, rebar in targets, etc and have yet to bend a half out. I have junked quite a few arrows but the halfouts have always been salvageable.
 
I run HIT inserts in my Victory RIP XV arrows (both .350 and .300 spine) with Gold Tip's XSmall Ballistic collars. and they've yielded excellent results. I glue in the inserts using Bob Smith Max-Cure glue, and hot melt for the collars. My arrows pull out of 3D targets easy, and mesh target faces without pulling out the insert, collar, and field point.

I built my Victory RIP XV .300 spine to be almost exactly the same weight as my .400 spine Axis arrows. The Victory arrows are 380 grains TAW, the Axis are 385 grains TAW. The difference is the former has a weight of 150 grains (125 grain point, 13 grain collar, 12 grain HIT insert) up front with 16% FOC, and the latter has 112 grains (100 grain point, 12 grain HIT insert) up front with 9% FOC.
I like the sounds of this. Would you mind showing a picture?
 
I like the sounds of this. Would you mind showing a picture?
I forgot to mention I run Easton X-nocks in my Victory arrows. I just like how much better the fit, and shoot from my bows. 5/16", 125 grain points fit perfectly on the ballistic collars.
 

Attachments

Discussion starter · #26 ·
Mule deer and elk primarily. I like a forgiving/accurate bow, an arrow around 400-450 grains (280-290fps), and a good sharp mechanical broadhead.
Those are pretty much my exact specs of my arrow builds as well. I just got some severs to try on deer and might give them a shot on elk as well. I got the 1.75s. I’ve typically ran the qad exodus.
 
21 - 28 of 28 Posts