Search Results for ‘archers advantage’

I am looking for advice on printing a sight tape using Archers Advantage and MR-LABEL MR500 Labels with my laser printer for my Black Gold Verdict Sight. I have printed some tapes using plain paper and clear packing tape to check the yardage marks. I have to cut the tape in half vertically to...

So I have a CBE Engage Hybrid that I am wanting to set up for Total Archery Challenge now that hunting season is over. I’d like to attempt to make a 100+ yard (thinking 130) tape for it which is capable on archers advantage. Problem is I can’t select my sight from the choices on AA. So would...

I am trying to setup up a new bow and sight in AA software but can't figure how to input the info for a HHA optimizer lite sight (the one with the arch site tapes). I appreciate anyone's help.

Been using AA for probably 6 years now and haven't noticed an issue till this past season. Im super critical when getting proper measurements and specs when inputting data but seemed to get a sight tape that's slightly off. Ive read that you can use sight in marks (30yd & 60yd seem to be most...

I have been using archers advantage to try and calculate the most accurate tape possible. I have everything entered but because the fast eddie does not have a scale. What is the best way to calculate marks? What would i use to put in for my short range mark? Do i use the distance from the top of...

Trying to decide on some new arrows for hunting (whitetail) and target shooting. Have been looking at Easton Da torch arrows after having them recommended to me. I had been looking at the Easton HEXX and was told to look at Da Torch becuase it was basically the same arrow but with the UNI...

I'm primarily looking to run arrow spine and maybe print sight tapes in the future. Can anyone please tell me which one they personally feel is easier to use or more accurate. Thanks for your input. If there is another software out there better please let me know. Thanks

Hi ! I'm trying to configure AA to be used with my new CBE Elite Target Sight. In the drop menu of the sight configuration panel, CBE isnt available. There are many others configuration available like 24 turns x 10 clicks, 24 turns X 20 clicks and so on......Which on to choose? Please help me !

I am pretty new to AA (only printed my first sight tape yesterday). I have a question, though: Is it possible to just print a calibrated scale off with AA, which is longer than 4" (10cm)? Specifically, I am trying to print the following for a friend (shooting recurve): actual scale itself must...

I have a few questions and would appreciate some help: 1) just how (from where to where) do I measure peep height above arrow at full draw? top of arrow to middle of peep hole? (I need to explain to the wife) 2) can I save my own set-ups? Thanks!

Hey Any helpful folks out there with Archer's Advantage or OnTarget 2 want to run two set of numbers for me? I would be (almost) eternally grateful: 1) For shooting indoor spots: Hoyt Contender Elite, with XT2000 limbs, Cam .5+, DW 59.5#, DL 28 ¼” – would an Easton X7 2312 with 200gr pro...

I entered my 20yard and 80yard marks into five archery software programs and compared the resulting estimated sight marks with my actual sight marks. The programs I tested were Archers Mark Web (AM) Archers Advantage (AA) OnTarget2/Software For Archers The Archery Program (TAP) X-Sight (X)...