Archery Talk Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Bow Tuning
    I've had a nock left tear with my Drive NXT for almost a year now at this point, I shoot around 45 - 50 pounds, 31 inch(+) draw, right handed, I've done everything from shimming the cams as far left as I can, messing with the yokes, moving the cablebar out(clockwise), last thing I have left to...
  2. Hoyt Archery Discussion
    So I've been having some sleepless nights the past 2 nights until I was able to figure out what was going on with my tune. RX7 Ultra 70# 28.5" draw RH VAP TKOs. 150 up front. 430 gr Using the Nock 2 It Thumb Release Been going to the range trying to group my Iron Will broadheads with my field...
  3. General Archery Discussion
    Ok guys, so as the title states I have a left tear issue i cannot resolve. Its a Logic 28'' draw, 70# limbs. GT hunter xt 340s w/ 100 gr points. Cams are in sync. center shot at 13/16. good form. The only way i can get rid of tear is to move the rest so close to the riser that i have no...
  4. PSE Archery Discussion
    Perform X 3D – 60lbs – 30 “ dl (low Left tear) Cable stops touching same time. Running Center of Berger hole (raised nock point to get the low tear out) Tried everything on left tear. I have spaced both cams to the left as to where there is only 1 thin spacer on left - 2 thin and 1 thick on...
  5. General Archery Discussion
    First off, I know there have been dozens of threads over the last 5 years on this subject, however I think my situation may be slightly different than the norm. I'll summarize first then give details afterward. For discussion note when I say the top of the idler wheel leans to the "left" I...
  6. Bow Tuning
    2009 X-Force Dream Season Gx "Left Tear" The bow is in time at full draw and with the timing marks on the cams. The rest is a limbdriver pro, blackhawk vapor arrows 300 spine or CF 350 Max. The CF arrows tear even worse. I'm to the point of being tired of tuning this bow. Anyone find a solution...
1-6 of 6 Results
Top