Hello, does anyone know where I can get one of these? Thanks!

I am new to archery, so this may be a dumb question, but I recently bought a PSE Prophecy and would like to increase the draw weight. I loosened the limb support screws like the owner's manual said, and the limb bolts don't seem to want to tighten (or loosen for that matter). They seem to be...

I have had a faktor turbo for a month or so now. It's a 70lb. bow, but when the archery shop measured it as shipped from hoyt it came in a few pounds over so the tech backed off the limb bolts just a bit to set it right at 70lbs. I am wondering is it best set this way or is it better set with...

Hello all, It's my first post so I'd like to say thanks to everyone who writes regularly with advice on all aspects of archery and especially for beginners. I have only recently started archery, about 6 months or so, and from the opinions on this forum I chose to buy a TradTech Pinnacle. It is...

Hi I have a 2009 VE with XT2000 cams. The limb bolts seem VERY stiff though - it takes pretty much as much force as I can put into it (with a normal Easton "multi" allen key) to turn the limb bolts - and it's not because the side bolts or the bolt at the back (i.e. inside of the riser) is tight...

I bought my wife a Chaos One Cam (NI) and it arrived yesterday - it is slightly too heavy for her and also an inch too long. but the limb bolts seem to need a larger allen key than even the largest one in the Easton tool. Any idea what size hex is needed to adjust these? Is it necessary to...

Hey I "stripped" the bolt hole (i.e. the hole that you put the Allen key in) on my 2009 Vantage Elite last night (I think there must be some rust inside from shooting in the rain a month or so ago). So now I can loosen the "loose" side, but not the other side and cannot adjust poundage...