Search Results for ‘rkc’

Anybody know where to find a 7/32" peep sight? 1/4" is a little too big and 3/16" is a little too small.

I decided to do a little broadhead testing today at the range after hearing how much better Slick Tricks (100 grain standards) fly as compared with the Thunderhead (100 grains also). It seems the Thunderheads get dogged pretty bad on here at times. I also shot an arrow tip with a 100 grain...

Can anyone tell me what is recommended for the nock height location on the Trophy Taker with the the small sized launcher arm. Is it 90 degrees, +1/16", +1/8" ,etc,etc It is on an '07 Guardian

I recently put on a Black Gold Redzone 7 pin sight on my bow for the two extra pins. I have only had five pin sights in the past, I wanted the 7 pin because at the club I shoot at we have a lot of 70+ yard shots on the walk through course. The pin gaps seems "normal" for the first five pins 20...

I posted this in the general discussion forum but I am not getting much feedback thought I would try the bowhunters: I just put together a new hunting arrow 28" FMJ 340 (11.3 gpi) with 100 grain tip and 2" Blazers = 462 grain total weight. Using the Goldtip calculator the FOC on this arrow is...

I just put together a new hunting arrow 28" FMJ 340 (11.3 gpi) with 100 grain tip and 2" Blazers = 462 grain total weight. Using the Goldtip calculator the FOC on this arrow is 9.9%. Will this be a problem for a hunting arrow shooting fixed blade broadheads? I am shooting Slick Tricks...

I took arrows some fletched with 2" Blazers and other with 4" vanes on the safari course at my archery club today just to see if there was any difference in accuracy or trajectory. I did not notice any difference. What did stand out to me very noticeably was how loud the Blazers were compared...

Anyone have problems fletching Blazers on small diameter arrows like FMJ's? I am thinking of trying it myself with the new Bohing Blazer helical jig.

Has anyone used a Bowmaster press on a Guardian? I know you don't need to press these bows because you can back out the limb bolts far enough, but that takes forever when you are putting your cams in sync and making very small adjustments each time. You know press, adjust and put it back in...

For Sale: A like new B-Stinger 12" with 11 oz. weight in Realtree HD Green. Used a couple of times but in perfect condition. $70 TYD (Lower 48 USA only) paypal, money order or cashiers check only.

I am in the market for a new seven pin hunting sight and have it down to the Montana Blackgold Flashpoint Redzone and the Spot-Hogg Hunter Hogg-It. There is alot out there about the Spot-Hogg so I would like to know from those who have used the Redzone what they think either pros or cons.

I would like to replace my 5 pin trophy ridge sight with a seven pin sight for hunting. I like the Spot-Hogg Hunter Hogg-it, Seven Deadly Pins and the Montana Blackgold Flashpoint Super Seven. Have any of you used these and what do you think of them pros and cons. Thanks!!!

I want to use a teflon cable slide on my '08 Allegiance to help with cable wear and I tried the Sims one and it holds the cables so close together at brace that they rub against each other when drawn. Which ones have you used that work well and hold the cables over far enough to shoot Blazers...

I have just completed installing new strings on my '08 Allegiance. I measured the strings under pressure in a string jig and twisted them into spec and then installed them. I synced the cams at full draw on a draw board which only required me to take two twists out of one cable. Measuring...

I installed my peep this week on my new bow. I shot it at least 300 times before doing so to let the string settle in. The peep is tied in at the correct height, but is skewd off to the right about 45 degrees. The good part is the peep stays at this angle all the way to full draw so at least...

The cables on my '08 Allegiance may have been installed incorrectly from the factory. I need a close-up picture of your cable guide to see if I have it correct now. Please post pic is you are able. Thanks!

The factory string silencers that came on my Allegiance are starting to fall apart after about 200 shots so I decided to dig through my archery cabinet to see what I had to replace them with. I Found a package of Super String Leeches. The package says that two leeches weigh 60 grains for...

Want to Buy: '08 Allegiance Black Speed Modules for 30" draw = EFA1.5 In black only please. I you have a set you want to sell send me a PM. Thanks!

Willing to buy: '08 Allegiance black 29.5" speed mods = EFA2.0 Please send me a PM if you have one set you are willing to sell. Thanks

I just bought a new '08 Allegiance and have only had two other bows neither of which had a draw stop as far as I know. I do like it becasue this bow has a hard back wall. It looks like the draw stop is adjustable. Why would I adjust this and what will that do?