Archery Talk Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 386 Results
  1. Bow Tuning
    Background... Worked this bow up last year to the "T". It was shooting dimes at 30 yards. I had worked it up at 70 lb draw weight. I also had tuned my arrows, I had a 5 arrow set (for hunting) that were like laser beams going down range. And except for occasional thwacked shots (my bad form)...
  2. General Archery Discussion
    Hey guys. Really cant figure out what my issue is here. My Hoyt I shoot now was already "tuned" from my pro shop when I bought it. I was curious about nock tuning my arrows so I decided to rip my fletchings off and give it a try. Shooting bareshafts through paper I was really nock left. No...
  3. Bow Tuning
    Just wondering.... Think I know the answer. I tend to find my DL is very sensitive to changes. When the bow is short of my proper DL I fling shots badly because I am cramped up and not aligned properly. When it is long for my proper DL, when I get to full draw the bow is not totally in the...
  4. Hoyt Archery Discussion
    So I've been having some sleepless nights the past 2 nights until I was able to figure out what was going on with my tune. RX7 Ultra 70# 28.5" draw RH VAP TKOs. 150 up front. 430 gr Using the Nock 2 It Thumb Release Been going to the range trying to group my Iron Will broadheads with my field...
  5. General Archery Discussion
    I had my bow shooting bullet holes, but realized that both top and bottom cam bearings were shot. I got new cams sent in from Mathews (warrantied) and am now getting a left tear after getting it back from the shop. Intersting to not my sight tape and left and rights were the exact same when...
  6. General Archery Discussion
    So I recently built a new set of strings for my realm and have had some tuning issues since installment. So I'll start by saying my last set i built were imo a killer set of threads when it came to performance. Awesome grouping, easy tuning, good speed. Only downfall was a slight peep rotation...
  7. General Archery Discussion
    To find the correct arrow length and spine combination I went off of eastons spine chart to get the correct spine. Starting with arrows a little long to trim down. I fletched one shaft and and kept another bareshaft. Bow is tuned and shooting bullet holes through paper. I sighted in fletched...
  8. F.I.T.A, N.A.A., Collegiate Archery, And J.O.A.D.
    Just put in an order for a new riser and it got me thinking, how much does a riser affect the tune of a bow? At first I thought it wouldn't change much but I also figured since its the one part in contact with almost all other parts of your setup it probably is important. It doesn't directly...
  9. Bow Tuning
    Hey guys, just wanted to post about some struggles tuning my Supra. 60# Rh was getting constant right tears. Standard tuning at 13/16 really doesn't work. From factory they are shimmed left and I had to adjust to nearly 1 1/8". Then timing was off because I am an idiot and put my nock too high...
  10. Bow Tuning
    Hey guys, just wanted to post about some struggles tuning my Supra. 60# Rh was getting constant right tears. Standard tuning at 13/16 really doesn't work. From factory they are shimmed left and I had to adjust to nearly 1 1/8". Then timing was off because I am an idiot and put my nock too high...
  11. Bow Tuning
    Hey guys, just wanted to post about some struggles tuning my Supra. 60# Rh was getting constant right tears. Standard tuning at 13/16 really doesn't work. From factory they are shimmed left and I had to adjust to nearly 1 1/8". Then timing was off because I am an idiot and put my nock too high...
  12. Bow Tuning
    Hi everyone, I'm from Italy and I'm tuning my bow for 70m for the first time. I use a TFT-G with 70-30 limbs at 30.5 (real poundage 35) and ACE 620 (with 120grains points). I'm preatty confident with my indoor setup, with several <550 points during tournament and <560 during my practice at 18...
  13. General Archery Discussion
    I have a mathews triax with the bottom cable alignment hole dead on and the top alignment hole slightly off. But heres the kicker. Both stops are hitting at the same time and ive bare shaft tuned the bow out to 20yrds and its shooting bullets! Should I adjust the cable and start all over or...
  14. General Archery Discussion
    Have an Elite Ember for my girlfriend and was wondering how I yoke tune these. On my top cam I have twisted one side of yoke and untwisted the other, and my timing changed…am I supposed to do top and bottom? I put the twists back and timing is perfect again. I’ve got a left tear FYI
  15. Elite Archery Discussion
    I picked up a new Remedy, and prepped shafts for tuning. Shafts are Gold Tip Hunter XT 300 spine cut to 27.5” with 100 grain inserts out of a 65# draw at 28”. Using 125 grain tips for now. I discovered that my paper tear changed with nock rotation while shooting bare shaft, and it was very...
  16. General Archery Discussion
    I’m over thinking this and driving myself nuts so I’m gonna ask you guys (stupid question incoming). I just bought an Elite Enkore. Picked it up today. Building a completely new set of arrows for it (I also have a Bowtech Solution, which is why I say completely new set). So my (stupid) question...
  17. General Archery Discussion
    Hello everyone! I just got myself a brand new Bear compound dual cam bow, 40-60lbs Im running it at 60lbs 27.5in draw. Its a pretty good bow, but i am having a very hard time trying to get it in tune, on a blank shaft tune it shoots knock up every time very agresivly. I will sight my feild...
  18. General Archery Discussion
    Hello everyone! I just got myself a brand new Bear compound dual cam bow, 40-60lbs Im running it at 60lbs 27.5in draw. Its a pretty good bow, but i am having a very hard time trying to get it in tune, on a blank shaft tune it shoots knock up every time very agresivly. I will sight my feild...
  19. Bear Archery Discussion
    Hello everyone! I just got myself a brand new Bear compound dual cam bow, 40-60lbs Im running it at 60lbs 27.5in draw. Its a pretty good bow, but i am having a very hard time trying to get it in tune, on a blank shaft tune it shoots knock up every time very agresivly. I will sight my feild...
  20. General Archery Discussion
    The question is both sight and rest could affect the horizontal shot placement and ideally I want to set one of them perfectly and to isolate the other for adjustment. So should I set my sight's windage at 20 yards then proceed with the rest of the tuning or I just leave the sight untuned and...
1-20 of 386 Results
Top