Archery Talk Forum banner

vane clearance

  1. Mathews VXR blazer contact

    General Archery Discussion
    I've had a VXR for a couple months now; I've attempted few different arrow configurations and for some reason my VXR cannot shoot blazers without cable contact. Bareshafts shoot bullets, centershot is at 13/16, arrow runs dead center through berghole. For some reason I just cannot shoot blazers...
  2. Good rest for vanes?

    General Archery Discussion
    Been using a Bear Weather Rest, but seems my vanes are hitting it a lot as the vanes are marking up the rest. I don't want a drop away rest, but am looking for something better. I shoot BB/BH but might make a switch to BHFSL don't know just yet... Far as a rest, I have a old springy on my old...
  3. BoDoodle Rest (Gamedropper) setup

    General Archery Discussion
    I am having difficulty getting cock vane clearance when using this rest. It is not hitting the arms, but the rotating carrier - when the arms flip down the back flies up and nicks the tip of the vane. I have tried rotating the rest cw (right hand bow) lowering the back of the rest. That works...
  4. drop away rest for a Mathews Z7

    Bow Tuning
    i am sure there a ton of people out there using a QAD Ultra Rest. I have the LD version on my Z7. i am pulling 66.5 pounds and 29.5" draw. the rest is slid as far forward as it can go. My launcher goes vertical about 3/4" before full draw. BUT, heres my issue......my vanes are still coming in...
Top