Archery Talk Forum banner
1 - 2 of 2 Posts

· YouThinkIcan't?!WatchMe
Joined
·
7,435 Posts
Discussion Starter · #1 ·
Hello Guys
Right now I'm building a arrow saw using 80/20 extruded profile (scrap pieces free) and a sewing machine motor 7000RPM. I will design and machine a collar on lathe to accept cut-off wheel. It will be very easy to replace. My question is what kind of blades are you guys using? I prefer to buy from Harbor Freight since they are very cheap , but any other place is good too. If you can please specify the blade size , thickness and middle hole diameter.
Thank You
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top