Archery Talk Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2,186 Posts
Discussion Starter #1
I have a 2008 katera that I love. I measured my ATA and it is 33 3/8's inches. It is supposed to be 33. It is 29 inch draw. The brace height is 6 1/8 but I took off the one piece grip and put on side plates. Is this a problem? Should I get it back in specs?
 

·
Registered
Joined
·
1,584 Posts
the quick answer is yes , get the ata back where it needs to be to perform at its max potetial.
the grip really isnt a 'problem' , you need to measure brace at the uper most portion of the grip section of the riser , so i would put the original grip back on to pull a brace measurement. it should be 6".
 
1 - 2 of 2 Posts
Top