[mike 04 gt]

I just Check the Axle to Axle mesurements on my bow and it is off about 1/4" of an Inch. what will this affect. at full draw it feels like it dont fall all the way into the valley. what will the A2A being short affect?

 

[mike 04 gt]

also how do you correct this? remove twist from the string or cable?

 

[carbon arrow1]

axle to axle and even brace height are approximate measurements. the important thing is the draw length. is it a little short, a little long, or just right?

 

[mike 04 gt]

draw lenght is fine. but it feels like it is not going all the way into the valley.

 

[carbon arrow1]

what kind of bow? does it have adjustable drawstops on the cams?

 

[mike 04 gt]

alpine f1, yes it has draw stops on the cams. i have adjusted the stops back to where the string will not even reach the draw stops. and it still doont fill like the letoff is @ 80% maybe 60%.

 

[carbon arrow1]

don't move them too far back, you could over-rotate your cams and lock your bow up. you may have to tweek the cables.

 

[mike 04 gt]

what do i need to do to the cables?

 

[carbon arrow1]

here is a good source of knowlege. http://archeryhistory.com/archerytalk/The_Nuts&Bolts_of_Archery.pdf

 

[mike 04 gt]

thanks for the help i tryed with removing 2 twist from each cable. i can tell the DW lowered but not much on the letoff. that got me to about 33.75 on my
A2A. do i need to take off more twist or just live with the let off?

 

[rolyat008]

The cams on alpines are a little different i think. You need to have the top cam rotated slightly more than the bottom (but not too much more or it can achieve 100% let-off and lock up). Try just twisting one of the cables to get the cams in time and achieve more let-off.