[Rgarbarino]

Today I did more tweaking and I'm to the point where I think I'm satisfied with the results even though it's not perfect. Raised the nock a little, double checked cam timing, made sure limb bolts were evenly tightened, one was slightly looser. Shot several rounds and results were very consistent. For those that were commenting on my previous post, I am shooting the target at shoulder height, my yard slopes downhill so I am shooting from lower than where the target is sitting. Followed up with a shot through paper and got a good hole. That's all I'm doing for now, tomorrow I will hit the range and shoot some distance and see what happens.

 

[Mathews4ever]

I tried a little bare shaft tuning myself today not the best results now I have to paper tune again but it seemed my bare shafts kick tail one way compared to my fletched does that mean any thing?

 

[Rgarbarino]

Tail left and right bare shaft usually will indicate a spine issue.

 

[Mathews4ever]

Thanks not sure if it matters as long as my BH are shooting well.