Archery Talk Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Bear Element

Hi there. I have just bought a bear element, and I need to adjust the draw length from 29" to 25" 26" and 27". I have the RSH2, RSH3 and RSH4 (currently on the bow). Does any of these fit to the required size, or do I need to buy extra modules? If so, is there any suggestion going online?

BTW, What size are the modules I have?
 

·
Registered
Joined
·
4,734 Posts
My manual has your cam in it. It says the #2 mod is the longest, and numbers 3 and 4 are each an inch shorter.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #6 ·
Thanks a lot. I have another question btw. I measured my arm-span and divided it by 2.5. It gave me 27". Do I have to subtract the loop and the trigger's length?
 

·
Registered
Joined
·
2 Posts
If you don't need the #2 module, I'll buy it from you.

Here is the table for the modules and draw legths.

Module Truth Code Instinct Element
Rockstop #1 30" 31" 30" 31"
Rockstop #2 29" 30" 29" 30"
Rockstop #3 28" 29" 28" 29"
Rockstop #4 27" 28" 27" 28"
Rockstop #5 26" 27" 26" 27"
Rockstop #6 25" 26" 25" 26"
Rockstop #7 24" 25" 24" 25"
Rockstop #8 23" 24" 23" 24"
 

·
Registered
Joined
·
4,473 Posts
Thanks a lot. I have another question btw. I measured my arm-span and divided it by 2.5. It gave me 27". Do I have to subtract the loop and the trigger's length?
Shouldnt but could depend on the release you got I suppose. Better way to check your dl is stand straight, put your fist against a wall like your holding a bow, look at wall like you would be shooting then measure from wall to right corner of mouth if your right handed.
 
1 - 11 of 11 Posts
Top