Hi....2 ideas. 1) you could get a piece of clear saran wrap and put it over the nock end or 2) you could use a gasket sealer and it will harden and set...heat the shaft to remove but is will leave a residue.

 

Cut small slivers of vinyl wrap,and affix to the bottom of the nock. I use this method on my arrows and it works great. 3/16"wide and 1/4" long is about right.

 

No one knows of Nocks that actually work on these? Also has anyone else had this problem?

 

Those are the nocks that will fit the closest and the saran warp is the easiest way to get them to fit snug.

 

I have this problem as well. Saran wrap works. You can also use a small piece off a plastic sack. Cut off about a 2" x 1" piece and twist it around the bottom of the nock. Snugs right up.

 

Have you looked into ignitor lighted nocks? The down side for you may be that you have to glue in a bushing, but I started using them last year in standard diameter carbon arrows and really was pleased.

The bushing will add a little more weight, but the nice thing is it is really just a thill bobber light stick / battery that you can replace.


Sent from my iPhone using Tapatalk