I bought one last month. It was very stiff to move. I called support and they had me back 2 screws out about a 1/4 turn. If you look at the sight you will see which ones to turn.


Sent from my iPhone using Tapatalk

 

Right next to wheel in front?

I bought one last month. It was very stiff to move. I called support and they had me back 2 screws out about a 1/4 turn. If you look at the sight you will see which ones to turn.


Sent from my iPhone using Tapatalk

 

I have two of them and the 2nd was very hard to move about in the middle of the slide. I mean it was difficult to turn the dial. After close inspection I found a burr from machining that wasn't clean up and after I removed it it got better. I would suggest to give them a call as you don't want to start turning screws and mess things up, i think there is 2 screws that the instruction say do not adjust.

 

Yup mine is stiff but doesn't seem to be a problem. Going on 4 years now!

 

To be clear, don't mind stiff, but mine is inconsistent. The middle is REAL stiff.

Called they said send it back. It should be consistent in stiffness.

Thanks for all the replies.

 

I'm pretty sure they offer a no questions asked warranty service for life like QAD.

 

Mine is stiff in the middle as well. I just figured that is how they are and never questioned it. Would love to hear if they do conclude it is an issue.

 

Just an update. I called back again before sending back, and a different person pointed me to the two screws to loosen and it is fine for me now. I didn't want to leave this out there as an issue, as it is a sweet sight!!

 

I always thought stiff was good

 

Mine is the same. I have no problem with it and would buy 10 more

 

It typically is the derlin block the wheel presses against isn’t square causing inconsistent pressure up and down the slide. It’s the reason I quit using my mbg and only buy geared sliders like Hha and spot Hogg. It will work just fine I just get annoyed by it

 

Can you (or anyone) further explain the differences in systems? I’m looking to add one and don’t want to spend money on something that won’t work or last a decade.

 

I had one and the travel was smooth .

 

 

It's those 2 little screws. Don't want to turn much. Mine about 1 16th or so was better for me.

 

Mine does the exact same thing. Almost like there is a little hump in the middle. Hasn't really bothered me since I'd rather have it tight and not even worry about it moving without using the lock nub. What does bother me is the sqeeeek I get at times. Any remedies for this?

 

I didn't loosen much, just a bit as I have rheumatoid. I still leave the adjuster unlocked. Will lock it down when hunting.