Archery Talk Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
1,033 Posts
Discussion Starter #1
If someone is shooting 29 inch draw,which hole should cam be set on? Same thing for 65% letoff? Pics. would be great.
 

·
Registered
Joined
·
422 Posts
The A slot would be 30 in. The B would be 29 in. and so on. Don't forget to move the stop. You will have two choices for each slot. Being 65 and 80 percent letoff.
 

·
Registered
Joined
·
5,401 Posts
What is the stop?
you have 3 screws to remove to adjust dl...2 for the module and 1 for the draw stop....the draw stop is th eblack rubber cylinder that the cable bumps against at full draw.....on the big part of the cam you will see letters A-F and 2 rows of holes....that is for the draw stop and the furthest out for the letter is the high letoff position and the closest to center is the low letoff...make sure the stop is on the same letter the module is rotated to
 

·
Registered
Joined
·
1,033 Posts
Discussion Starter #7
In the picture were there is two,on my cam there is only one.The bow is shooting great,what problems could happen?
 

·
Registered
Joined
·
5,401 Posts
then it sounds like it backed out..lucky it didn't get your limb...or if they changed your draw length when the bow was setup they didn't get it back in?there should be 2 in the mod....go back to the store you got it and have another put in with a touch of wax on the threads
 
1 - 9 of 9 Posts
Top