Archery Talk Forum banner

1 - 3 of 3 Posts

·
Premium Member
Joined
·
10,326 Posts
Discussion Starter #1
Ok so I have a question about how to use these things. I have had one in my box for YEARS but have never used it. I usually just "eyeball" level for my nock point. It has worked for a long time but I was just curious on how do you "actually" use the thing? It has 1/8" increments on it from 1/4" to 0" I assume the arrow nock goes on the 0's markings and the brass nock goes just above that then you would bring you arrow rest "valley" up to it and all in all it should all be level, correct??:confused:
 

·
Registered
Joined
·
47,473 Posts
I set the square so it's passing the center of the berger hole then use the marks to place my bottom tied in nock point (at 1/8" below the center 0). Then I nock and arrow and tie in the top nock point (if I use one on that setup) then tie my loop around it all. I can then set my rest so the arrow crosses the berger hole and I'm done. I eyeball centershot then shoot paper and group tune afterwards.
 

·
Premium Member
Joined
·
10,326 Posts
Discussion Starter #3
Thanks :)
 
1 - 3 of 3 Posts
Top