Archery Talk Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
32 Posts
Discussion Starter · #1 ·
Hello, recently bought a bowtech realm x. I tightened my limb bolts without first loosening the CP dual lock screw. I realized this was a mistake and cranked them back down. Did I cause any damage or do I need to do anything else before shooting the bow? Thanks
 

· Mark
Joined
·
6,714 Posts
Go to Bowtechs webpage and scroll to bottom. Select Downloads, select Revolt ( not Realm) manual. Follow steps to adjust. There is ONE screw to loosen prior to limb adjustment. Being you said dual I’m questioning if your adjusting the correct screw.
Realm manual does show this but Revolt does, same set up.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top