Archery Talk Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter #1
Axle to Axle is 1/4" too long, specs call for 33 1/4 and mine is 33 1/2. Cam is in correct timing. What is the best way to correct this without messing up cam timing? Thanks
 

·
Registered
Joined
·
196 Posts
Make sure that your brace height is off too. Make sure you are measuring from the middle of the axles when doing the measurement. If both the A to A is too short and the brace height is too long, then you need to untwist the string/cable. To keep the timing mark approx the same, do twice as many untwists to the string as what is done to the cable. That should keep the timing roughly the same.


I know my Liberty is a little off on the A to A (I think it's somewhere around 1/8th an inch), but the brace height is right on. The specs can vary some depending upon the bow. That's why I would recommend checking your brace before making any changes.
 
1 - 2 of 2 Posts
Top