[BULLDOG25]

I would have to assume you have twisted limbs or bent axles. Is it as bad a you a indicated in you image????

 

[denn10]

would check axles on piece of glass and swap limbs while at it like said

How is the bow? in spec ATA BH cam timing????

 

[Black Mamba]

If I rest an arrow shaft on the bottom cam it makes about 3° angle with string!
BH is ok, ATA is 0.5 inch longer (I make custom strings and cables) because I need 27.5 DL while cam holes are only 27,28,29 and 30"! Timing and cam synchronization is ok!
Could I fix the problem if I put a shim between cam and limb?
I'll verify if bottom axle is bent.

Thanks

 

[xecutioner]

have the same problem right now w/ my vantage x8 bottom cam leans draw stop catches just the edge of the cable . tried switching limbs , limb pockets and new strings, just ordered new cam bearings should be in tommorrow hope it works.

 

[jim46ok]

Cam Lean

Hi. I am not familiar with your bow. You said it had a "floating yoke". Does that prevent you from twisting one side of the yoke or other to align cam? Also, I hear some guys "serve over' the floating yoke to make it a "static" yoke, giving more control over adjustment. Some convert to static yoke. Can't wait to hear how you fixed it. Good Luck