Archery Talk Forum banner

1 - 5 of 5 Posts

·
Hunter/Gatherer
Joined
·
13,334 Posts
Discussion Starter #1
Can someone please tell and post some pics of a correct way to tie serving. Im having issues and i need to serve above where my Expert Pro is connected to my cables.... Help please!!!!
 

·
(aka lug nut)
Joined
·
48,307 Posts
Can someone please tell and post some pics of a correct way to tie serving. Im having issues and i need to serve above where my Expert Pro is connected to my cables.... Help please!!!!
http://www.archerytalk.com/vb/showthread.php?t=1334651&referrerid=22477


You can do a long tied nocking point.
Just tie an overhand knot with the tag ends below the bowstring,
then...

grab the tag end and tie an overhand knot above the bowstring,
then...

tie an overhand knot with the tag ends below the bowstring,
then...

grab the tag end and tie an overhand knot above the bowstring,
then...

keep repeating,
and you will build a series of overhand knots next to each other.

When the series of overhand knots are say 1-inch long,
then,
tie the overhand knot on the same side of the bowstring twice
(say tie the overhand knot below and do it again...below the bowstring)
and cut off the tag ends say 1/4-inch long.

Rotate the tag ends so that the tag ends are horizontal
and melt the horizontal tag ends with a bic lighter.

Come in with the flame from the side, and you will not burn your bowstring or cable.

http://www.youtube.com/watch?v=Q37qX9aDj9c
 

·
Registered
Joined
·
2,617 Posts
The only correct way is when it stays in place. Lots of different methods out there. I'll use over hand alternating knots on the peep, but a nail knot above and below the peep and just a nail knot to tie my rest string to the cable. I'm sure if you checked YouTube they should have some video's.
 
1 - 5 of 5 Posts
Top