Archery Talk Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
338 Posts
Discussion Starter #1
Hi, I had been experiencing some noise on my SF Forged Plus riser and somebody on a thread here mentioned
washers under limb bolts. Well I added them and now no problem with excessive noise. Plus they also protect
the limbs on the limb bolt section. Attached photos. Regards
Norman Delrin Washers1.jpg Delrin Washers2.jpg
 

·
Registered
Joined
·
338 Posts
Discussion Starter #3
Where did you get these?
Hi, 1" diameter Delrin Washers at ACE Hardware, .44 cents each glued under limb bolts with Super Glue. Regards
Norman
 

·
Life is short, live it!
Joined
·
1,193 Posts
Hi, 1" diameter Delrin Washers at ACE Hardware, .44 cents each glued under limb bolts with Super Glue. Regards
Norman
I was going to ask if you had spares in your quiver. Can the bolts be removed and then replaced exactly where they were in the event of one breaking?
 

·
Registered
Joined
·
338 Posts
Discussion Starter #5
I was going to ask if you had spares in your quiver. Can the bolts be removed and then replaced exactly where they were in the event of one breaking?
Hi, No Spares in my quiver. Delrin Washers don't brake so once glued under limb bolts they stay there. I have my
limb bolts 3 1/2 turns out from completely tight so I can always repeat process but I have not had to touch
the limb bolts at all. Regards
Norman
 
1 - 5 of 5 Posts
Top