[scott123]

Bow is shooting well but beyond 30yards seems to open way up. Noticed the lean in the lower cam and worked with Gilbert to try to clean it up but didn't get crazy with it but it didn't appear to go away easily with a few twists of the yoke opposite the lean.

Shot through paper and has the tiniest rest left tear but we setup the center shot and its perfect.

Anyone dealt with lean issues or do any of you destoryer owners notice the same issue at all with your bow?

pencil flat against the cam

against the other side of the cam.

 

[DAO 1950]

Scott, If you haven't already read this you will need to.http://www.archerytalk.com/vb/showthread.php?t=1118006. It will answer all of your questions and some that you didn't know you had.

 

[bambieslayer]

that lean is going the wrong way and is a bit extreme unless your'e a southpaw
my stock harness gave me fits put a set of customs on set the cams square set nock height square centered on berger holes and straight down the center could not tune 350 spines went to 300's
on these bows leave the rest and nock height alone bareshaft through paper tune the harness for bullet holes
tail left twist left yokes untwist right opposite for tail right
tail low top yokes bottom yokes for tail high
good luck pm me if you need to

 

[DannyZack]

do some yoke twisting and your problem will be fixed

 

[scott123]

I just didn't know why three full twists of the yoke on the one side didn't pull the lean out? Its an aftermarket string but was never setup much because even with this lean it cuts a decent hole in paper.

 

[DannyZack]

what i would do is untwist the leaning side and twist the opposite side