Archery Talk Forum banner
1 - 6 of 6 Posts

·
(aka lug nut)
Joined
·
53,682 Posts
I’m trying to make a draw board with my ez green.
But I can’t get it to draw evenly.
Any tips to get it to work properly? View attachment 7645940

When the pipe and the winch are at the same height, top of bow tilts backwards.
WHY? Cuz the d-loop needs to be CLOSER to the top axle
and the pivot point of the grip (top of your bow hand) where the pipe is located,
ALWAYS needs to be LOWER than the d-loop.



If you want the riser to be vertical,
then, the strap needs to run DOWNHILL from winch to the pipe of the draw board.
 

·
Registered
Joined
·
273 Posts
So the option is either raise the crank end up by about 3" to 4" or lower bow bracket the same distance and it should level out your bow. And while doing so I would think of other options instead of wooden dowels as the support structure.
 

·
Registered
Joined
·
273 Posts
Nice diagram and a good starting point if it actually works for this application for use with an EZ press. Played with the winch height on my diy draw board with a couple of different bows and found that I needed about double that distance than stated on the Archery Dezign instructions.
 
1 - 6 of 6 Posts
Top