Archery Talk Forum banner

Draw Length Draw Stop Installation on a Bear Attack E-Cam

1273 Views 3 Replies 2 Participants Last post by  JBragg
Good morning,

I recently purchased a Bear Attack and have a question about adjusting the draw length. I removed the existing module (#8) and replaced it with the proper one (#7) without issue. However, when I removed the screw to disengage the draw stop and reposition it from the 8 hole to the 7 hole, I dropped it. My question is this: Is there a particular side of the draw stop that needs to face the cam? Both sides look the same and I can't tell if it's possible to accidentally install it backwards for lack of a better term. It doesn't appear to matter and the screw threads in the way I've installed it just fine. However, if there is a particular orientation for it of which I'm unaware, I'd like to know so I can avoid any long term issues that could potentially arise if this is a problem. Thanks in advance.

~J.B.
1 - 4 of 4 Posts
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top