Archery Talk Forum banner

1 - 3 of 3 Posts

·
redman
Joined
·
8,129 Posts
Discussion Starter · #1 ·
how would easton axes fmj 500 do for a field arrow does any one make a pin nock that will fit and a glue in tip i was told that a acc 3-28 points will fit is that true the price is right on them
 

·
Registered
Joined
·
2,637 Posts
They shoot quite well but are very heavy, even more so than the FMJ Navigator. I don't think there is an option for nocks other than the factory one. At least that's what I was told when I was looking at them.

Dave
 

·
Registered
Joined
·
3,868 Posts
If you can get G-nock unibushings for them, which I'm sure you probably can, you can get pins to fit in those unibushings.

Easton A/C/E pins will fit in the G-nock unibushing. They're too tight to go right in, but that is easy to overcome. Chuck the pin in a drill and spin the ferrules in some 220 grit sandpaper to remove a little bit from them until the go in snug. Takes 10 seconds! A little hot melt glue will keep them in there.

Works great.
 
1 - 3 of 3 Posts
Top