Archery Talk Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4,473 Posts
Discussion Starter #1
Got a used bow for a friend, trying to set up. Reflex grizzly. Came with 1 button near arrow nock. Also cam with 2 above lower cat whisker. I am going to install d loop so one at arrow nock is now not needed and the 2 above whiker is 6" off cam. I would think this would add to vibration instead of eliminate? Is this correct? Whiskers are tied off nice so thought Id cut the buttons off and maybe add 2 nocks 1" from cams(this is a cam 1/2) on each end. Should I remove these? And should I add the nocks? Im trying to eliminate as much vibration as possible. Not worried about gaining speed. TY
 

·
bow nut
Joined
·
4,699 Posts
They are just spares in case the one at the arrow nock breaks in the feild. Then you just slide up the next one. I don't think they will add any vibratiopn but you can get rid of a few grains.
 

·
Registered
Joined
·
4,473 Posts
Discussion Starter #3
Anyone think the nocks near cams like speed nocks will eliminate any noise/vibration or not enough to notice? Just doing what I can before he gets it. TY
 
1 - 3 of 3 Posts
Top