Archery Talk Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3,435 Posts
Discussion Starter #1
Just bought a Judge which has the #3 rev cams for a 28" draw, After finally getting it set up I went out to give the bow the run down. Shot the bow a couple of times but something just didn't feel right. Headed for the "man cave" to check all the specs.

Brace height is right on @ 6"
ATA: is @ 34 11/16" (spec 34 14/16) +/- .1875
Draw weight @ 70#
Draw stops and timing right on the money.

Here is the problem: #3 module should make it a 28" draw. After checking and double checking it sits at only 27.5" (that is why something just didn't feel right).

I don't think I could untwist the string enough to get a 28" draw out of this module. Which would also mess up all other measurements.

Are these mods running short on the Judge??????? Any suggestions????
 

·
Registered
Joined
·
1,397 Posts
I just bought a Judge also. That makes my third Elite. My Synergy is at 27.5", my GT500 is at 27.5". But on the Judge I had to go with a 28". Could be just me but the 28" in the Judge felt better. I know this info doesn't help but your not alone.
 
1 - 3 of 3 Posts
Top