Archery Talk Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1,265 Posts
Discussion Starter · #1 ·
I just picked up an EVL 34. Just wondering how folks are running the arrow in relation to the berger hole and if you are running a dead level nock height.

Thanks.
 

·
Registered
VXR31.5 29" 60#/65# EVO EVL34 SE #65
Joined
·
38 Posts
Same here.

Be really careful tightening ALL the bolts and even putting some glue on them. Te bow vibrates A LOT and some screws get loose because of that (in my case the roller guide rod screws, the string stop and the module ones).

Also get some limb dampeners...
 

·
Registered
Joined
·
698 Posts
Same here.

Be really careful tightening ALL the bolts and even putting some glue on them. Te bow vibrates A LOT and some screws get loose because of that (in my case the roller guide rod screws, the string stop and the module ones).

Also get some limb dampeners...
Can't say that I've had any issues with vibration on my EVL 34 I did however have a bent cable guard rod which PSE replaced but I went with Titanium archery products cable guard rod which is much nicer then the carbon fiber one. I do not run any limb dampeners on mine and never had any screws back out.
 
1 - 5 of 5 Posts
Top