Archery Talk Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
603 Posts
Discussion Starter #1
Hi all,

I did some searching and couldn't seem to find an answer online.

Does anyone know if all of the Evolve Cam (not SE, but EC) let-off mods are the same?

Specifically, if I have low let-off mods from an Evolve bow, will that mod work on an Evoke with EC cams, even though it is the newer 1/4" axle cam?

Thanks in advance.
 

·
Registered
Joined
·
49,494 Posts
The let of on the Evolve cam system is built into the stops. You just adjust it to the let off you want. 80, 85 or 90 percent.
 

·
Cayuta Creek Outdoors
Joined
·
2,478 Posts
The let of on the Evolve cam system is built into the stops. You just adjust it to the let off you want. 80, 85 or 90 percent.
They also have low let-off modules that you can swap out that will give you 65%, 70%, or 75% let-off. That's what the OP is asking, and yes they should both fit.
 

·
Registered
Joined
·
603 Posts
Discussion Starter #5
Thank you everyone. Appreciate the responses!
 

·
Registered
Joined
·
3,716 Posts
The let of on the Evolve cam system is built into the stops. You just adjust it to the let off you want. 80, 85 or 90 percent.
That's partially true.

High Letoff (HL) = 80-85-90 based on the draw stop you set it on. These are what come stock on the bow when you buy it.
Low Letoff (LL) and Fast Letoff (FL) = 65-70-75

The FL are a big more aggressive and give you a few more FPS over the LL mods.

All 3 mods will work on any bow using the bigger EC cams. The smaller EC cams have the same setup of HL/LL/FL, but the mods are smaller to accommodate the smaller cam and will not work with the EC's. So be careful what you buy if going used.
 

·
Registered
Joined
·
496 Posts
The small evolve cams are the SE cams and can only use the high let off or low let off modules. PSE does not make a fast low let off mod for the SE cam. EC mods do not fit SE mods and vice- versa
 
1 - 8 of 8 Posts
Top