Archery Talk Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
396 Posts
Discussion Starter #1
Any one have a recipe for footing the axis ,
 

·
Registered
Joined
·
396 Posts
Discussion Starter #4
Thanks


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
396 Posts
Discussion Starter #7
600 spine


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
12,058 Posts
You need to measure the outside diameter with a caliper or micrometer, be careful and accurate. Then use this chart prepared by "dan in mi" to determine what aluminum shaft you need.

What you want is an aluminum shaft that has an inside diameter that is 0.0073" larger than the outside diameter of your carbon shafts. For example, if the OD of your carbon shaft is 0.2732" you would want a 2016 that has in inside diameter of 0.2805". I'd use a good two part 24 hour epoxy for glue.

 

·
Registered
Joined
·
396 Posts
Discussion Starter #10
Thanks for the information.


Sent from my iPhone using Tapatalk
 
1 - 10 of 10 Posts
Top