Archery Talk Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
2,289 Posts
Discussion Starter #1
Anyone else have problems with the nozzle part getting clogged up?? I leave it standing upright when not in use, but always gets crap in the tip...
Ive also had a large bottle, that I know the cap was on just harden up, not hard but to thick to pour!! Stuffs to expensive for that to happen to!!!
 

·
Registered
Joined
·
838 Posts
I use a pin in the hole and forget the cap, works for me
 

·
Registered
Joined
·
278 Posts
before you put the cap on each time you need to wipe it off. this will keep the cap clean and it will then close all the way and it wont clog up.
 

·
Retired GI "still serv'n"
Joined
·
13,960 Posts
wipe it clean, stick a stick pin in the hole then put the cap on it...should be OK then.
 

·
Registered
Joined
·
5,835 Posts
I have had good results by tapping the bottom of the bottle on a hard surface to shake the remaining glue out of the nozzle, then squeezing the bottle a few times to blow enough air through the nozzle to make sure it is completely cleaned out before putting the cap back on.

Automan
 
1 - 6 of 6 Posts
Top