Archery Talk Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
3,803 Posts
Need more info.

What type of rest are you using.
Have you checked for fletching clearance?
Have you checked for Idler or cam lean?
Has anyone checked to make sure you are not torquing the grip?
Is your bow in tune - Cam rotated properly, ATA and BH on spec?
What type of tuning method have you tried - Walk Back, Paper, etc?


Arrow spine is important, however, usually if arrow flight is very erratic, the first thing I look for is fletching contact. Once you have eliminated contact ENTIRELY, then you can start tuning. I don't even bother trying until I have checked for this. Good Luck!
 

·
Registered
Joined
·
122 Posts
the charts show you should be using 7595's, you are under spined.
 

·
Registered
Joined
·
5,901 Posts
you might be able to get away with that poundage if you downsize to 100gr. tip. You may have to lighten the tip and poundage to shoot that shaft. I shoot the same shaft on 62#'s and 28" shaft with 100gr. point and tears bullet holes. Your just a little heavy for it.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top