[Bassattackr]

Anyone using this combination? Any issues? Clearances to quiver OK?

 

[ultratec.joe]

I just put the Epsilon on my Vent Pro 33 to replace my QAD. Love the way it shoots. However, bare shaft tuning is difficult . The TEC riser makes if very difficult to get at the horizontal adjustment screw. The index marking are completely covered by TEC riser bar. My thought is that once I have it dialed in, ill be set and those things will not matter. But I just told a friend that I will be calling Hamskea on
Monday to see if they have a more Hoyt friendly rest in stead of the Epsilon.

 

[bmook019]

I had one on my ventum pro and swapped it to the trinity. The center shot adjustment was impossible to get to with a stubby wrench.

 

[ultratec.joe]

I called Hamskea today and discussed the issues I have with the Tec Riser. They said it has been more of an issue of late with Hoyt's new risers (the Pro Ventum and VTM) being built with less room between the riser bar and the grip. The guy said that the Trinity might give us a bit more room but not much. And they have nothing in the works to address this problem. Just for Info!

 

[Bassattackr]

Wow. I’d rather not go back to QAD again. Even if they have the integrated rest..

Trinity seems quite a bit heavier than the epsilon?

Wonder if the Hybrid Hunter would work?

 

[Bassattackr]

Ended up going Trinity. We’ll see how it works!

 

[bmook019]

The trinity is working very well for me.