Archery Talk Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
246 Posts
Discussion Starter #1
have read several mentions of"make sure no harness contact with lower axel shaft or upper cam bearing hub".
but no explanation...
what would cause this"contact" and how do you fix it??
 

·
Registered
Joined
·
4,273 Posts
Cause of this happens when the limb stops are set past there appropriate number. Which calls the cam to over rotate. Causes this cable to bearing hub contact.


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
246 Posts
Discussion Starter #4
ok,can see that having bottom stop moved past longest of given range for dl would lead to
contact.but say draw stop is in the" range "but there is contact,could there be cable/string
length issue?i would believe if true more than likely ata,max dw,or dl would be off.dose my
thinking sound right?just trying to learn for "incase"run into contact issue.thanks for response
 

·
Registered
Joined
·
170 Posts
You shouldnt have an issue as long as your draw stop is in the right range. If you do, I would get a hold of Xpedition....they are very helpful
 
1 - 5 of 5 Posts
Top